%0 Journal Article %T Numerical and analytical investigation of an ultrasonic assisted ECAP process %J Journal of Theoretical and Applied Vibration and Acoustics %I Iranian Society of Acoustics and Vibration and Avecina %Z 2423-4761 %A Eskandarzade, Mehdi %A Masoumi, Abolfazl %A Faraji, Ghader %D 2016 %\ 07/01/2016 %V 2 %N 2 %P 167-184 %! Numerical and analytical investigation of an ultrasonic assisted ECAP process %K ECAP process %K Ultrasonic vibrations %K Forming forces %K Friction %R 10.22064/tava.2016.22472 %X One of the great challenges in the processing of materials using Equal Channel Angular Pressing (ECAP) is the high forming forces required to produce large shear deformation in the material. Researchers show that the friction forces between the die and the sample constitute a great part of the total forming forces. Recently, ultrasonic vibrations are successfully implemented into the ECAP process with the aim of reducing the friction forces. However, there is still need to optimize the parameters of ultrasonic vibrations in the ECAP process using numerical methods. FE simulation of the ultrasonic assisted ECAP process is very time-consuming and during simulation, the constant ram speed has interaction with the vibration speed. A virtual increase in the ram speed for simulation of ultrasonic assisted ECAP process will affect the results. By using Coulomb and Dahl friction models, it is analytically shown how vibration speed and constant ram speed interact with each other during FE simulation. The results clearly suggest against using virtually higher speeds in numerical modelling of the vibrated ECAP process. The conclusion is reached through comparing several simulations, as well as an analytical formulation, with experimental data from literature. The required friction coefficient values to be used in FE simulation at high contact forces are measured experimentally. An alternative strategy is then offered to speed up FE simulation of the vibrated ECAP process without the need for a virtual increase in the ram speed. The proposed strategy can increase the simulation speed of the ultrasonic assisted ECAP process up to ten times   %U https://tava.isav.ir/article_22472_7e49256143bfa1637069e819d0e35bd9.pdf